Wet Areas

Bathroom Epoxy Waterproofing

Seal pipe inserts, nahani traps and sunken slabs, often without breaking tiles.

Overview

We take care of every leak-prone area of a bathroom: gaps around pipe inserts, nahani traps and sanitary ware, sunken portions, splash zones and wall-slab junctions, using our epoxy waterproofing system.

Bathroom leaks show up as damp patches on the ceiling below or peeling paint on the other side of a wall. The cause is almost always the joints: tile grout, pipe penetrations and floor traps.

Epoxy grout is non-porous, so water cannot pass through it the way it passes through cement grout. Where the sunken slab itself is saturated, we treat it with injection grouting or a full re-waterproofing.

Water absorption of epoxy grout: 0%
Tile breaking in most cases: No
Days per bathroom: 1–2

How the job runs.

Step 1
Leak trace
Moisture meter and flood test to isolate the source.
Step 2
Rake out
Remove old cement grout from joints.
Step 3
Epoxy fill
Fill joints and pipe collars with epoxy grout.
Step 4
Seal
Treat traps and corners, then flood test again.

From our sites